When necessary, design or install a cleaning device near the periphery of the machine and it can be recycled. It has stable operation, low noise, convenient cleaning, flexible maneuverability, continuous use, and superfine dispersion and emulsification of materials. When we use the machine, the liquid material must be continuously input and cannot be retained or keep a certain amount of liquid material in the container.
The high shear emulsifier is suitable for working under normal pressure, vacuum and positive pressure.. Steps to replace the stator: first unscrew the three nuts with a wrench, remove the outer stator ring, remove the damaged or unsuitable stator, and then put the high-quality stator on the step, then install the outer stator ring, and screw it. All power supplies of the components, immediately pull out the plug to complete the power off. It is necessary to avoid empty machine operation, so as to avoid high temperature or crystalline solidification of the material during processing, which will damage the equipment to a certain extent, so we strictly prohibit idling! After the machine is produced, the equipment must be cleaned and cleaned up first. And clean every part on the working head in time to keep it clean and tidy, which is convenient for next use.
This can not only keep the working efficiency of the stator and rotor from being affected, but also protect the airtightness of the machine. If the high-shear emulsifier has not been used or processed for a very long period of time, we should first check whether the various mechanical parts are intact and clean before use. Good nuts, evenly and at the same time keeping balance, tighten them slightly, and use the hand plate to rotate the rotor shaft. There should be no tightness.
After the high-shear emulsifier stops working in mechanical operation, we need to retract the speed control handwheel of the control box to the starting position as initially, and turn off the main switches of all power sources and cut off all machine zeros in the shortest time. We should pay special attention to the electrical In terms of safety performance, this design concerns the safety of the equipment, so we can use an ohmmeter to detect whether the machine has a short circuit or other abnormalities. The working head of the high-shear emulsifier is strictly prohibited from leaving stainless steel Bright beer tank factory the liquid medium for independent operation during production, so as to avoid damage to the machine's bearings during high-speed operation, which will affect work efficiency and cause unnecessary mechanical failures
Kommentarer
Inga kommentarer